A_d_s_ PH30.2 Manual do Utilizador

analog and digital systemsPH30.2owner's manualfront_cover.qxd 10/26/56 5:13 AM Page 2

System 7 - Two PH30.2’s are used. The first PH30.2 is configured the same as system 4 and the secondPH30.2 is configured similar to system 5. The firs

10

1. 2ch/4ch input switch- Leave this switch OUT if you are using 4 channels of input. Push the switch IN if you have only 2 channels of input to send

installation1. Disconnect the battery ground cable. Reconnect the ground cable only after the installation is complete and the wiring has been checked

speaker connections for stereo configurationsMinimum recommended impedance is 2 stereo. Speaker terminals accept up to AWG #12 speaker wire.speaker c

signal sourcesDue to the wide input level adjustment range, all a/d/s/ PowerPlates™ can be driven with either aconventional preamplifier drive signal

internal signal routing2-channel/4-channel input switch - routes RCA input from channels 1/2 to channels 3/4. When the switch is engaged, channel 1 in

multi-cross™ crossover configurationxover control 1/2- The crossover selection for channels 1 & 2 has three options:When the switch is in the left

Constant Bass circuitTo mix sub-bass information into channels 1/2 and 3/4, select a low-pass crossover point, and use the level controls to set the l

adjusting input sensitivityThe input sensitivity setting is important to ensure proper performance, low noise levels, and maximumsystem reliability. A

table of contentsintroduction 1about this manual 2features of your PowerPlate™ 2warning and tips 3mounting locations 3system planning 4system configur

troubleshootingsymptom possible cause action to takeno output low or no remote turn-on check remote turn-on voltage input output at amplifier and

symptom possible cause action to takedistorted output (cont’d) speakers are blown check system with known working speakers and repair orreplace as nee

specificationsamplifier section PH 30.2power output 4 (watts)1 6 channel 6 x 753 channel 3 x 250power output 2 (watts)2 6 x 112.5fuse type 70 A ma

warranty informationLIMITED TWO YEAR CONSUMER WARRANTYDirected Electronics, Inc. promises to the original purchaser, to replace this product should it

aDirected Electronics, Inc. All rights reserved G49200 09-02front_cover.qxd 10/26/56 5:13 AM Page 1

about this manualTo get the most from your a/d/s/ PowerPlate™, we recommend that you have the installation performedby your qualified authorized a/d/s

warnings and tipsAlways disconnect the battery ground wire before doing any work on your vehicle. Reconnect the cableonly after the installation is co

system planningProper system planning is the best way to maximize your PowerPlate’s™ performance. By planning yourinstallation carefully you can avoi

system configurationsAll a/d/s/ PowerPlates™ provide extensive features, which make a variety of system configurationspossible. It is not feasible to

System 2 - PH30.2 used in 5-channel mode with the AC502 providing level control for bridged channels5 and 6. 1 and 2 are high-passed for front speaker

System 4 - PH30.2 used in 4-channel mode with high-pass tweeters and bandpass midrange. Channels1and 2 are configured high-pass for the main tweeters

System 6 - PH30.2 used in 3-channel bridged mode with two channels dedicated for the main speakersand one bridged channel pair used for a subwoofer. C